LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Belt Idler Pulley
    GM1959938Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley (2) and bolt to the generator bracket.

    Snug the bolt finger tight.

    2. NOTE: Refer to Fastener Notice.
  2. Tighten the drive belt idler pulley bolt (1).

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals