LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Magnet Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The gasket surface should be free of oil or other foreign material during assembly.
    Fig 1: View Of CMP Actuator Magnet, Bolts, Gasket & Oil Seal
    GM1658168Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
  2. Install the CMP actuator magnet (752) to the front cover.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CMP actuator magnet bolts (751).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  4. Connect the engine harness electrical connector to the CMP actuator magnet.
  5. Install the water pump. Refer to Water Pump Replacement (RPOs LY2/LC9/LY5/LMG/LFA) .
scientia non olet · About LEMON Manuals