LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - Off Vehicle >> Engine Front Cover Removal

Engine Front Cover Removal

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Cover, Bolts & Gasket
    GM1658162Courtesy of GENERAL MOTORS CORP.
  1. Remove the front cover bolts (501).
  2. Remove the front cover (502) and gasket (503).
  3. Discard the front cover gasket.
    4. Fig 2: View Of CMP Sensor Wire Harness & Bolts
    GM1658163Courtesy of GENERAL MOTORS CORP.
  4. Remove the camshaft position (CMP) sensor wire harness (737) and bolts (738).
    5. Fig 3: View Of CMP Sensor & O-Ring
    GM1658166Courtesy of GENERAL MOTORS CORP.
  5. Remove the CMP sensor (703).
  6. Remove the O-ring (704) from the sensor, as required.
    7. Fig 4: View Of CMP Actuator Magnet, Bolts, Gasket & Oil Seal
    GM1658168Courtesy of GENERAL MOTORS CORP.
  7. Remove the CMP actuator magnet (752), bolts (751), and gasket (753).
  8. Remove the oil seal (140).
scientia non olet · About LEMON Manuals