LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - Off Vehicle >> Engine Coolant Air Bleed Pipe and Hole Cover Removal

Engine Coolant Air Bleed Pipe and Hole Cover Removal

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Coolant Air Bleed Pipe
    GM1401993Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine coolant air bleed pipe bolts (309).
  2. Remove the pipe (307) with seals (308).
    3. Fig 2: Engine Coolant Air Bleed Cover Bolts
    GM1402001Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine coolant air bleed cover bolts (312).
  4. Remove the covers (313) with seals (308).
    5. Fig 3: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
  5. Remove the seals (308) from the pipe and covers.
  6. Discard the seals.
scientia non olet · About LEMON Manuals