LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - Off Vehicle >> Crankshaft and Bearing Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Passages & CKP Reluctor Ring Teeth
    GM1402145Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use care when handling the crankshaft. Avoid damage to the bearing surfaces or the lobes of the crankshaft position (CKP) reluctor ring. Damage to the teeth of the CKP reluctor ring may affect on-board diagnostics (OBD) II system performance.
  1. Clean the crankshaft with solvent.
  2. Thoroughly clean all oil passages (2) and inspect for restrictions or burrs.
    3. CAUTION: Refer to Safety Glasses Caution .
  3. Dry the crankshaft with compressed air.
scientia non olet · About LEMON Manuals