LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - Off Vehicle >> Camshaft Installation

Camshaft Installation

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft
    GM1704626Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If camshaft replacement is required, the valve lifters must also be replaced.
  1. Lubricate the camshaft journals and the bearings with clean engine oil.
  2. Install the camshaft sprocket bolt into the camshaft front bolt hole.
    3. NOTE: All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft bearings.
  3. Using the bolt as a handle, carefully install the camshaft into the engine block.
  4. Remove the bolt from the front of the camshaft.
    5. Fig 2: View Of Camshaft Retainer & Camshaft Retainer Bolt
    GM1969013Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The gasket surface on the engine block should be clean and free of dirt or debris.
  5. Install the camshaft retainer (203) and the bolts (204). Install the retainer with the sealing gasket facing the front of the engine block.
    6. Fig 3: View Of Camshaft Retainer & Bolt
    GM1967334Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Tighten the camshaft retainer TORX® head bolts.

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

scientia non olet · About LEMON Manuals