LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Engine Exhaust System) >> Repair Instructions >> Exhaust Hanger Mounting Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust Pipe Hanger Bracket & Bolts
    GM1708691Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust pipe hanger bracket to the transmission.
    2. NOTE: Refer to Fastener Notice .
  2. Install the exhaust pipe hanger bracket bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the left and right catalytic converters. Refer to Catalytic Converter Replacement - Left Side (2500 )  and Catalytic Converter Replacement - Right Side (2500 ) .
scientia non olet · About LEMON Manuals