LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Rear Propeller Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of lubricant. If the splines of the slip yoke do not have a sufficient coating of lubricant, lubricate the shaft with lubricant GM P/N 12345879 (Canadian P/N 10953511) or with an equivalent lubricant meeting GM specification 9985830 (RWD w/4 speed Automatic Transmission).
    2. Fig 1: View Of Propeller Shaft & Transmission Or Transfer Case
    GM404287Courtesy of GENERAL MOTORS CORP.
  2. Install the propeller shaft into the transmission or transfer case.

    Align the reference marks made during removal.

    3. Fig 2: Identifying Driveshaft Pinion, Yoke Retainers & Bolts
    GM361391Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft (3) to the rear axle pinion yoke (4).

    Align the reference marks made during removal.

    4. NOTE: Refer to Fastener Notice .
  4. Install the yoke retainers (2) and bolts (1).

    Tighten:  Tighten the yoke retainer bolts to 25 N.m (18 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals