LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Propeller Shaft And Universal Joints) >> Diagnostic Information and Procedures >> Leak at Front Slip Yoke

Leak at Front Slip Yoke

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Checks Action
DEFINITION: A few drops of lubricant that are leaking from the splined yoke are normal. This condition does not require attention.
The slip yoke barrel is burred, nicked, corroded, or worn.
  1. Inspect the slip yoke for burrs.

    Careful use of crocus cloth or fine stone honing can remove minor burrs.

  2. If the yoke is badly burred, corroded, or worn, replace the yoke. Refer to Universal Joint Replacement .
  3. Replace the oil seal. Refer to one of the following procedures:
There is a faulty oil seal in the transmission or in the transfer case output shaft. Replace the oil seal. Refer to one of the following procedures: