LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement (9.25 Inch Axle) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Hose & Wiring Bundle
    GM341716Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front differential carrier shield, if equipped. Refer to Shield Replacement .
    3. IMPORTANT: Make note of the routing in order to aid in reassembly.
  3. Remove the vent hose (1) from the wiring bundle (2), S4WD axles only.
  4. Remove the vent hose from the retainer clips, all axles.
    5. Fig 2: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS CORP.
  5. Remove the vent hose from the differential carrier assembly.
  6. Remove the vent hose from the vehicle.
scientia non olet · About LEMON Manuals