LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Front Drive Axle) >> Repair Instructions >> Front Axle Vent Hose Connector Replacement (9.25 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose Connector
    GM847064Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose connector into the differential carrier assembly.

    Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

    2. NOTE: Refer to Fastener Notice .
  2. Tighten the vent hose connector.

    Tighten:  Tighten the vent hose connector to 28 N.m (21 lb ft).

    3. Fig 2: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS CORP.
  3. Connect the vent hose to the vent hose connector.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals