Front Axle Lubricant Level Inspection (8.25 Inch Axle)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Clean the area around the front axle fill plug.
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification: The 8.25 inch axle the oil level should be between 12-16 mm (0.50-0.625 in) below the fill plug opening.
- If the level is low, add oil until the level is between 12-16 mm (0.50-0.625 in) for the 8.25 inch axle. Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the fill plug.
Tighten: Tighten the plug to 33 N.m (24 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.