LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (8.25 inch)  or Differential Carrier Assembly Replacement (9.25 inch) .
    2. Fig 1: Remove Upper Differential Carrier Assembly Bushing Using J 36616-2, J 33791-1, Thrust Bearing, J 21474-18 & Forcing Screw
    GM893247Courtesy of GENERAL MOTORS CORP.
  2. Remove the upper differential carrier assembly bushing by performing the following steps:
    1. Install the J 36616-2 (1), the J 33791-1 (2), the thrust bearing (3), the J 21474-18 (4), and the forcing screw as shown.
    2. Remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
    3. Fig 2: Removing Lower Differential Carrier Assembly Bushingj 21474-18, Thrust Bearing, J 33791-1, J 36616-2, & Forcing Screw
    GM892847Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower differential carrier assembly bushing by performing the following steps:
    1. Install the J 21474-18 (1), the thrust bearing (2), the J 33791-1 (3), the J 36616-2 (4), and the forcing screw as shown.
    2. Remove the lower differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
scientia non olet · About LEMON Manuals