LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 257 (Automatic Transmission - 6L50/6L80/6L90 - DTC P0973 To DTC P2764) >> DTC P2714 or P2715 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the Line Pressure Check .
    • If the pressure is out of specification, correct this concern first.
  2. Perform the Control Solenoid Valve and Transmission Control Module Assembly Cleaning and retest the DTC as outlined in the Circuit/System Verification steps.
    • If the DTC resets, continue on with testing.
  3. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
    • If a concern is found, repair or replace the control solenoid (w/body and TCM) valve assembly.
  4. Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test .
    • If the solenoid is found to be leaking or stuck closed, replace the control solenoid (w/body and TCM) valve assembly.
  5. Inspect the center support fluid passage seal assembly for cut or damaged seals.
    • If a concern is found replace the seal assembly.
  6. Inspect the control valve upper body assembly for sticking valves, damage, scored bores, or debris.
    • If a concern if found in the valve body, repair or replace the valve body as necessary.
  7. Inspect the 2-6 clutch assembly for damage.
    • If a concern is found in the 2-6 clutch assembly, repair or replace as necessary.
scientia non olet · About LEMON Manuals