Repair Procedures
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
If the IMS switch is replaced inspect the valve body detent spring to be sure it is centered over the detent lever. This will prevent the detent spring from hitting the IMS switch.
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
IMPORTANT:
Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection
for the following components before replacing the components.
- Manual Shift Shaft Position Switch Replacement for internal mode switch (IMS) replacement.
- Control Module References for control solenoid (w/body and TCM) valve assembly replacement, setup, and programming.