LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 255 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0700 To DTC P3449) >> DTC P2120, P2122, P2123, P2125, P2127, P2128, or P2138 >> Component Test

Component Test

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Perform the Circuit/System Testing before proceeding with the Component Test.

Dynamic Test

  1. Install a 3A fused jumper wire between the 5-volt reference terminal of the applicable APP sensor and 5 volts. Install a jumper wire between the low reference terminal and a ground.
  2. Sweep the sensor through the entire range while monitoring the voltage between the signal terminal and the low reference terminal with a DMM. The voltage should vary between 0.30-4.98 volts without any spikes or dropouts.
    • If the voltage is not within the specified range or is erratic, replace the accelerator pedal assembly.
scientia non olet · About LEMON Manuals