LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 254 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - DTC P069F To DTC P3449) >> DTC P3401, P3425, P3441, or P3449 >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Perform the Circuit/System Testing first.

Static Test

  1. Ignition OFF, disconnect the VLOM harness connector at the VLOM assembly.
  2. Connect the cable that is labeled resistance from the displacement on demand (DoD) tester to the VLOM connector.
  3. Connect the power leads from the DoD tester to B+ and ground. Test for 11-18 ohms on each VLOM solenoid.
    • If the resistance is not within the specified range for each solenoid, replace the VLOM assembly.
  4. Test for infinite resistance between each VLOM circuit terminal and the VLOM housing.
    • If less than infinite resistance, replace the VLOM assembly.

Dynamic Test

  1. Ignition OFF, disconnect the VLOM harness connector at the VLOM assembly.
  2. Connect the cable that is labeled power from the displacement on demand DoD tester to the VLOM connector.
  3. Connect the power leads from the DoD tester to B+ and ground.
  4. Command each VLOM solenoid ON and OFF using the DoD tester. You should be able to hear each solenoid turn ON and OFF.
    • If the function does not perform as specified, replace the VLOM assembly.
scientia non olet · About LEMON Manuals