LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 254 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - DTC P069F To DTC P3449) >> DTC P2534 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  1. Verify that DTC P0562 is not set as current or history.
  2. Ignition OFF, disconnect the harness connector of the FPCM.
  3. Ignition ON, test for greater than 11 volts between the IGN voltage circuit terminal 15 and ground.
    • If less than the specified voltage, test the IGN voltage circuit for a short to ground or an open/high resistance. If the circuit test normal and the ECM - IGN fuse 58 is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the RUN/CRANK relay.
  4. If all circuits test normal, replace the FPCM.
scientia non olet · About LEMON Manuals