LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0231 To DTC P0690) >> DTC P0641 or P06A6 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Ignition OFF, disconnect harness connector of the fuel pressure sensor.
  4. Ignition OFF, test for less than 1.0 ohm between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the FPCM.
  5. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the FPCM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the FPCM.
  6. If all circuits test normal, replace the fuel pressure sensor.
scientia non olet · About LEMON Manuals