LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0231 To DTC P0690) >> DTC P0506 or P0507 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The engine must first be running for greater than 60 seconds, then idle at a steady state for an additional 10 seconds before comparing the actual and desired engine idle speed parameters.
  1. Use a scan tool to compare the desired engine idle speed to the actual engine idle speed.
    • Actual engine idle speed should be no greater than 75 RPM below desired.
    • Actual engine idle speed should be no greater than 150 RPM above desired.
  2. If any other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals