LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0231 To DTC P0690) >> DTC P0496 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF.
  2. Seal the EVAP system using the Purge/Seal function with a scan tool.
  3. Start the engine.
  4. Observe the FTP sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 volts after 90 seconds.
    • If the Fuel Tank Pressure Sensor parameter is greater than the specified range, replace the EVAP canister purge solenoid valve.
scientia non olet · About LEMON Manuals