LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0231 To DTC P0690) >> DTC P0420 or P0430 >> Repair Verification

Repair Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  3. After the conditions for running the DTC have been met, drive the vehicle at approximately 80 km/h (50 mph) for 60 seconds.
  4. Perform a closed throttle deceleration until the vehicle speed is less then 40 km/h (25 mph).
  5. Verify that DTC P0420 or P0430 has passed this ignition cycle.
    • If not passed or failed this ignition cycle, the test aborted resulting in an inconclusive test result. The above test may need to be repeated up to 5 more times during this drive cycle.
scientia non olet · About LEMON Manuals