Diagnostic Aids
WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- A misfire may only occur when the engine is operating under a load or when the engine is cold.
- A high resistance condition on any ignition control (IC) circuit can cause an engine misfire DTC P0300-P0308 to set without setting an IC circuit DTC P0351-P0358.
- This test procedure requires that the vehicle battery has passed a load test and is completely charged. Refer to Battery Inspection/Test .
- A misfire DTC could be caused by an excessive vibration from sources other than the engine. Inspect the following for possible sources of vibration:
- A tire or wheel that is out of round or balance
- Variable thickness brake rotors
- An unbalanced drive shaft
- Certain rough road conditions
- A damaged accessory drive component or belt
- A damaged reluctor wheel
- The Crankshaft Position System Variation Learn procedure may need to be performed.