LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0231 To DTC P0690) >> DTC P025A >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the FPCM.
  2. Ignition OFF, install a test lamp between the control circuit terminal 13 and ground.
  3. Ignition ON, verify that a test lamp illuminates for 2 seconds.
    • If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, replace the FPCM.
scientia non olet · About LEMON Manuals