LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - DTC P0230 To DTC P0690) >> DTC P0641 or P0651 (Set in ECM) >> Circuit/System Testing (Set in ECM)

Circuit/System Testing (Set in ECM)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Additional DTCs may set when disconnecting components.
  1. Ignition OFF, disconnect the harness connector of all the sensors connected to the 5-volt reference bus for the applicable DTC. Refer to Circuit/System Description above.
    2. IMPORTANT: A short to voltage on the signal circuit of certain components may cause this DTC to set.
  2. Ignition ON, test for 4.8-5.2 volts between one of the 5-volt reference circuits and ground.
    • If less than the specified range, test all of the 5-volt reference circuits for a short to ground. If all circuits test normal, replace the ECM.
    • If greater than the specified range, test for a short to voltage on all of the 5-volt reference circuits, or the signal circuit for each component associated with the appropriate 5-volt reference bus for a short to voltage. If all circuits test normal, replace the ECM.
  3. Connect each component associated with the appropriate 5-volt reference bus, one at a time, while monitoring the voltage. The voltage should not change more than 1 volt.
    • If the voltage display changes more than the specified range when a component is connected, replace the component.
scientia non olet · About LEMON Manuals