LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Automatic Transmission - 2ML70 - DTC P0218 To DTC P0967) >> DTC P079B >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTCs P0721, P0722, P0723, P0966, P0967, P0969, P0970, P0971, P0973, P0974, P0976, P0977, P2720, P2721, P2728, P2729, or P2730 are not set.
  2. Clear the DTC.
  3. Operate the vehicle from 1st through 4th gear while observing the Clutch 2 Slip Speed parameter. Stop the vehicle and turn the ignition OFF for 30 seconds. Perform this action 2 times. The Clutch 2 Slip Speed parameter should display 0 RPM when the Clutch 2 Status parameter displays Applied.
    • If any other transmission DTCs are set, diagnose those first.
    • If DTC P079B resets, go to Component Testing below.
scientia non olet · About LEMON Manuals