Component Testing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
- Perform the Control Solenoid Valve and Transmission Control Module Assembly Cleaning
in an attempt to clean or free up a potential sticking valve of dirt or debris.
- If the DTC resets after the cleaning procedure perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
- Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test
to test for a stuck open or stuck closed TCC PC solenoid valve inside of the control solenoid (w/body and TCM) valve assembly.
- If a stuck open or closed valve is found, replace the control solenoid (w/body and TCM) valve assembly.
- Inspect the lower control valve body for a stuck valve, debris or damage.
- If you found a valve body concern, repair or replace the lower control valve body as necessary.
- Inspect the TCC control valve in the pump.
- If you found a TCC control valve concern, repair or replace the TCC control valve or pump as necessary.
- Inspect the torque converter assembly for damage or discoloration.
- If you found a torque converter assembly concern, replace the torque converter assembly as necessary.