LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 250 (Automatic Transmission - 6L50/6L80/6L90 - DTC P0218 To DTC P0971) >> DTC P0736 >> Diagnostic Fault Information

Diagnostic Fault Information

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

The following fault table will help determine if a hydraulic circuit or an incorrect position or application of a component affects the transmission operation.

Component Cause DTCs
1-2-3-4 and 3-5-R Clutch Housing Assembly 1-2-3-4 clutch backing plate retaining ring not seated, causing the piston to over-travel and cut 1-2-3-4 clutch piston seal P0736
Automatic Transmission Fluid Filter Assembly Oil filter loose or damaged P0736
Center Support Assembly Center support fluid passage seal assembly, incorrectly installed, cut or damaged P0736
  • Center support fluid passage seal assembly, incorrectly installed, cut or damaged
  • Lube hole blocked, incorrectly drilled or omitted
 P0756
Control Solenoid (w/body and TCM) Valve Assembly Clutch Pressure Control Solenoid 3:
  • Always exhausting - Stuck On
  • Not exhausting - Stuck Off
  • Needle piston or armature pin binding
  • Control signal fluid supply leak - valve body filter plate assembly cracked or damaged gasket seal
  • O-ring seals leaking
 P0736
Fluid Pump Cover Assembly Fluid pump cover vanes and fluid pump rotor broken P0736
scientia non olet · About LEMON Manuals