Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Inner & Outer Shield Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

With the help of an assistant, position the fuel tank shield on the fuel tank.
Hand tighten inner fuel tank shield mounting nut.
Hand tighten the outer fuel tank shield mounting nut.

NOTE: Refer to Fastener Notice .

Tighten the fuel tank shield nuts.Tighten:
- Tighten the 6 mm nuts to 9 N.m (80 in lb).
- Tighten the 8 mm nuts to 18 N.m (13 lb ft).
Lower the vehicle.