LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Frame And Underbody) >> Repair Instructions >> Front Pull Winch Receiver Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Pull Winch Receiver
    GM797573Courtesy of GENERAL MOTORS CORP.
  1. Install the winch receiver to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the receiver bolts to the frame.

    Tighten:  Tighten the bolts to 85 N.m (63 lb ft).

  3. Install the bumper. Refer to Front Bumper Replacement .
scientia non olet · About LEMON Manuals