LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0010 To DTC P0230) >> DTC P0120, P0122, P0123, P0220, P0222, P0223, or P2135 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the scan tool TP sensor 1 voltage parameter. The reading should be between 4.75-0.33 volts.
  2. Ignition ON, observe the scan tool TP sensor 2 voltage parameter. The reading should be between 0.25-4.59 volts.
  3. Ignition ON, observe the scan tool TP sensor 1 and 2 parameter. The scan tool should indicate agree.
  4. Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC, or within the conditions that you observed from the Freeze Frame/Failure Records.
  5. Verify that DTC P0120 or P0220 are not the only throttle position DTCs set.
    • If DTC P0120 or P0220 are the only DTCs set, replace the control module.
  6. Verify that DTCs P0641 or P0651 are not set.
  7. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals