LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0010 To DTC P0230) >> DTC P0010 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Ignition ON, engine running, increase engine speed to between 1,200-1,500 RPM. Monitor the camshaft actuator solenoid with a scan tool while observing the following control circuit status parameters:
    • The CMP actuator solenoid ckt short to gnd test status
    • The CMP actuator solenoid ckt open test status
    • The CMP actuator solenoid ckt short to volts test status

      Each parameter should display OK.

  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals