Conditions for Setting the DTC
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
P0050 or P0056
- The ECM detects that the affected HO2S heater low control circuit is not within a specified range at engine start-up.
- DTCs P0050, and P0056 set within 1 second when the above condition is met.
P0059
- The ECM detects that the affected HO2S heater low control circuit is not within a specified resistance range at engine start-up.
- DTCs P0059 sets within 1 second when the above condition is met.
P0060
- The ECM detects that the affected HO2S heater low control circuit is not within a specified resistance range at engine start-up.
- DTCs P0060 sets within 1 second when the above condition is met.
P0155
- The ECM detects that the HO2S 1 heater current parameter is more than 3.125 amps or less than 0.25 amp.
- DTC P0155 sets within 120 seconds during the heater current test when the above condition is met.
P0161
- The ECM detects that the HO2S 2 heater current parameter is more than 2.875 amps or less than 0.25 amp.
- DTC P0161 sets within 120 seconds during the heater current test when the above condition is met.