LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 247 (Engine Control System & Fuel - 4.8L, 5.3L, 6.0L, Or 6.2L - DTC P0010 To DTC P0230) >> DTC P0010 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: You must perform the Circuit/System Verification first.
  1. Ignition OFF, disconnect C112.
  2. Test for less than 1 ohm between the low reference circuit terminal E and ground on the ECM side of harness.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Verify the test lamp does not illuminate between the ground circuit terminal E and the control circuit D on the ECM side of harness.
    • If the test lamp illuminates, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Remove the test lamp.
  5. Command the CMP actuator from zero to 25 degrees. Verify the scan tool CMP actuator ckt short to volts test status parameter is OK.
    • If not the specified value, test the control circuit for a short to ground. If the circuit tests normal, replace the ECM.
  6. Install a 3A fused jumper wire between the control circuit terminal D and the low reference circuit terminal E on the ECM side of harness. Command the CMP actuator to 25 degrees with a scan tool. Verify the scan tool CMP actuator ckt short to volts test status parameter is displaying Fault.
    • If not the specified value, test the control circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  7. Remove the water pump from the engine. Refer to Water Pump Removal (RPO LY2/LC9/LY5/LMG) or Water Pump Removal (RPO LY6/L76/L92) .
  8. Inspect and test the remaining CMP solenoid wire harness from C112 to the CMP solenoid for a short to ground or an open/high resistance.
    • If all circuits test normal, replace the CMP actuator solenoid.
scientia non olet · About LEMON Manuals