LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (Wiring Systems And Power Management - DTC B1380) >> DTC B1380 (BCM) >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Ignition Switch 

  1. Ignition OFF, disconnect the harness connector at the ignition switch.
  2. Using the Resistance Test table below, check the resistance between the terminals of the ignition switch listed in each switch position.
Resistance Test

Ignition Switch Position Terminals 4 and 2 Terminals 4 and 3 Terminals 4 and 5 Terminals 4 and 6 Terminals 5 and 6
Off Key Out Infinite Infinite Infinite Infinite Infinite
Off Key IN Infinite Infinite < 5.0 Ohms Infinite Infinite
Accessory Infinite < 5.0 Ohms Infinite Infinite Infinite
Run < 5.0 Ohms < 5.0 Ohms Infinite Infinite < 5.0 Ohms
Start < 5.0 Ohms Infinite Infinite Infinite 1275-1325 Ohms