LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0572 or P0573 >> Conditions for Setting the DTC >> P0572

Conditions for Setting the DTC: P0572

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

The ECM detects a low voltage signal on the TCC brake signal circuit for more than 2 seconds when the serial data message from the BCM indicates the brakes are applied. The ECM sets the DTC when the condition has been detected 8 out of 10 times.