LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection and Connection >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Negative Battery Cable At Battery
GM832902Courtesy of GENERAL MOTORS CORP.
CAUTION: Refer to Battery Disconnect Caution .
IMPORTANT: Clean any existing corrosion from the battery terminal bolt flange and the battery cable end.

Install the battery ground negative cable and bolt to the battery.

Tighten:  Tighten the battery terminal bolt to 17 N.m (13 lb ft).

scientia non olet · About LEMON Manuals