Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- The Conditions for Setting the DTC are no longer present.
- A history DTC will clear after 40 malfunction-free ignition cycles.
- The powertrain control module (PCM) receives the clear code command from the scan tool.
DTC P0563
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Starting and Charging Schematics Connector End View Reference: Engine Electrical Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
19 V | Go to Step 4 | Go to Step 3 |
| 3 | Replace the generator. Refer to Generator Replacement . Is the action complete? |
- | Go to Step 5 | - |
| 4 | Replace the powertrain control module (PCM). Refer to Control Module References
for replacement, setup, and programming. Is the action complete? |
- | Go to Step 5 | - |
| 5 |
|
- | Go to Step 2 | System OK |