LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> Charge Indicator Always On

Charge Indicator Always On

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Charge Indicator Always On

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn ON the ignition, with the engine OFF.
  2. Observe the Charge indicator on the instrument panel cluster (IPC).
Does the charge indicator illuminate?		 Go to Step 3  Go to Symptoms - Engine Electrical 
3
  1. Turn OFF the ignition.
  2. Disconnect the generator connector.
  3. Turn ON the ignition, with the engine OFF.
Does the charge indicator illuminate?		 Go to Step 4  Go to Charging System Test 
4 Test the charge indicator control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?		 Go to Step 6  Go to Step 5 
5 Replace the powertrain control module (PCM). Refer to Control Module References for replacement, setup, and programming.
Is the action complete?		 Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals