LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of VSS, Bolt & O-Ring Seal
    GM481937Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring seal (3) onto the VSS (1).
  2. Coat the O-ring seal (3) with a thin film of transmission fluid.
  3. Install the VSS (1).
    4. NOTE: Refer to Fastener Notice .
  4. Install the VSS bolt (2).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

    5. Fig 2: View Of Transmission Harness 20-Way Connector & VSS Electrical Connector
    GM858994Courtesy of GENERAL MOTORS CORP.
  5. Connect the VSS electrical connector (2).
  6. Lower the vehicle.
  7. Refill the fluid as required.
scientia non olet · About LEMON Manuals