LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Automatic Transmission - 6L50/6L80/6L90 - Introduction (2 Of 2)) >> Specifications >> Fluid Pump Selective Specifications

Fluid Pump Selective Specifications

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
Fluid Pump Selective Specifications

Size Classification Thickness (mm) Thickness (in)
IMPORTANT:
  • Rotor and slide must be chosen from the same size classification as the oil pump body.
  • Allowable rotor and slide to fluid pump body end play is as follows:

    Specification: 

    • Slide to Fluid Pump Body End Play - 0.020-0.051 mm (0.0008-0.0020 in)
    • Rotor to Fluid Pump Body End Play - 0.020-0.051 mm (0.0008-0.0020 in)

The fluid pump assembly has selective rotor and slide components. These components are chosen based on pump body dimensions. Fluid pump rotor and slide components are available in three size classifications (1, 2, 3) with the following tolerances:
Rotor Selection
1 17.948-17.961 0.7066-0.7071
2 17.961-17.974 0.7071-0.7076
3 17.974-17.987 0.7076-0.7081
Slide Selection
1 17.948-17.961 0.7066-0.7071
2 17.961-17.974 0.7071-0.7076
3 17.974-17.987 0.7076-0.7081
Fluid Pump Body Depth
1 17.98-17.994 0.7079-0.7084
2 17.994-18.007 0.7084-0.7089
3 18.007-18.033 0.7089-0.7100
scientia non olet · About LEMON Manuals