Transfer Case Adapter Replacement

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Adapter Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the transfer case. Refer to Transfer Case Assembly Replacement . Remove the transmission mount. Refer to Transmission Mount Replacement (4WD) or Transmission Mount Replacement (2WD) for the 4L60-E/4L65-E/4L70-E transmission, or Transmission Mount Replacement (2WD) or Transmission Mount Replacement (4WD) for the 6L50/6L80/6L90 transmission.
1	Transfer Case Adapter Bolt NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Transfer Case Adapter
3	Transfer Case Adapter Seal Tip: Always use a new seal for the adapter. Do not use any type of sealant or adhesive in place of or with the seal.