LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 231 (Transfer Case - Mp 3023/3024-NQH) >> Repair Instructions - Off Vehicle >> Transfer Case Assemble >> Rear Output Shaft Assembly

Rear Output Shaft Assembly

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Output Shaft Assembly
GM1849367Courtesy of GENERAL MOTORS CORP.
Rear Output Shaft Assembly

Callout Component Name
1 Transfer Case Front Output Shaft Drive Sprocket Spacer - Front
2 Transfer Case Four Wheel Drive Clutch Housing
3 Transfer Case Front Output Shaft Drive Sprocket
4 Transfer Case Four Wheel Drive Clutch Housing Retaining Ring
5 Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
6 Transfer Case Front Output Shaft Drive Sprocket Retaining Ring
7 Transfer Case Oil Pump Assembly
8 Transfer Case Rear Output Shaft Speed Reluctor Wheel
9 Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
10 Transfer Case Rear Output Shaft Rear Bearing Assembly
Tip: 
  • Use an arbor press or suitable installer to install the bearing to the rear output shaft.
  • Ensure the retaining ring groove in the outer race is positioned toward the rear.
11 Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
scientia non olet · About LEMON Manuals