Mp 3024 ATC
WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- The input shaft pilot bearing assembly is larger than the MP 3023 ATC in order to accommodate the larger rear output shaft. The outer diameter measures 41.275 mm (1.625 in).
- An input shaft pilot bearing retaining ring is used.
- The high/low clutch has neutral pointing engagement teeth. The leading edges of the teeth are symmetric.
- The rear output shaft is larger than the MP 3023 ATC.
- The front output shaft drive sprocket is 33.5 mm (1.319 in) wide.
- The front output shaft driven sprocket is 35.5 mm (1.398 in) wide.
- The rear output shaft rear bearing retaining rings are larger than the MP 3023 ATC. The inner diameter of the ring groove at the rear output shaft measures 38.5 mm (1.516 in).
- The rear output shaft rear bearing assembly inner diameter measures 41 mm (1.614 in). The width measures 18 mm (0.709 in).
- The rear output shaft bearing assembly surface on the rear output shaft measures 41 mm (1.614 in).
- The rear output shaft seal is larger than the MP 3023 ATC. The inner lip diameter measures 53.8 mm (2.118 in).
- The rear output shaft bushing is larger than the MP 3023 ATC. The inner diameter measures 56.08 mm (2.208 in).
- The rear case half has larger bores than the MP 3023 ATC in order to accommodate the rear output shaft seal and the rear output shaft bushing.
- The control lever is thicker than the MP 3023 ATC, measuring 10.5 mm (0.413 in) between the bearing surfaces.
- The control actuator lever is thicker than the MP 3023 ATC, measuring 10.5 mm (0.413 in) between the bearing surfaces.
- The control actuator lever balls are smaller than the MP 3023 ATC, measuring 10 mm (0.394 in) in diameter.
- The control actuator lever washer is thicker than the MP 3023 ATC, measuring 2.5 mm (0.098 in).