LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Bumpers And Fascias) >> Repair Instructions >> Rear Bumper Step Pad Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear License Plate Harness Electrical Connector
    GM1467091Courtesy of GENERAL MOTORS CORP.
  1. Open the spare tire carrier.
  2. Disconnect the rear license plate harness electrical connector at the RH end cap support brace.
    3. Fig 2: Harness Grommet
    GM1486513Courtesy of GENERAL MOTORS CORP.
  3. Release the harness grommet from the rear step pad.
    4. Fig 3: Spare Tire Carrier Mount
    GM1486508Courtesy of GENERAL MOTORS CORP.
  4. Remove the latch side (1) spare tire carrier mount from the rear bumper. Refer to Spare Tire Carrier Replacement .
    5. Fig 4: Rear License Plate Harness Electrical Connector
    GM1467091Courtesy of GENERAL MOTORS CORP.
  5. Pull outward at the rear edge of the step pad (1) in order to release the pad cover from the bumper.
  6. Remove the license plate electrical harness from the pad cover.
  7. Remove the pad cover from the rear bumper.
scientia non olet · About LEMON Manuals