LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Bumpers And Fascias) >> Repair Instructions >> Rear Bumper Replacement (SUV) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lift the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Rear Tow Eye/D-Ring (SUV)
    GM796193Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear tow eye/D-rings. Refer to Rear Tow Eye/D-Ring Replacement (SUT) or Rear Tow Eye/D-Ring Replacement (SUV) .
    3. Fig 2: Electrical Connector For Trailer Tow Receptacle
    GM1453814Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector for the rear trailer tow receptacle at the rear bumper (1).
  4. Remove the receptacle bolts (3) and receptacle (2).
    5. Fig 3: Push-In Retainers
    GM1467112Courtesy of GENERAL MOTORS CORP.
  5. Remove the push-in retainers (1) securing the bumper end cap (2) to the wheelhouse extensions.
  6. Remove the rear bumper end cap retainers and covers.
    7. Fig 4: Reinforcement Bar & Related Components
    GM1453817Courtesy of GENERAL MOTORS CORP.
  7. Remove the nuts (1, 3) securing the reinforcement bar (2) to the bumper end cap and trailer hitch bolt (4).
  8. Remove the rear bumper bolts behind the removed spare tire carrier mounting plates.
  9. Remove the bumper.
scientia non olet · About LEMON Manuals