LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Bumpers And Fascias) >> Repair Instructions >> Rear Bumper Replacement (SUV) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear bumper to the chassis frame.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 rear bumper bolts.

    Tighten:  Tighten the bolts to 32 N.m (24 lb ft) at the spare tire carrier mounts.

  3. Install the rear tow eye/D-rings. Refer to Rear Tow Eye/D-Ring Replacement (SUT) or Rear Tow Eye/D-Ring Replacement (SUV) .
    4. Fig 1: Reinforcement Bar & Related Components
    GM1453817Courtesy of GENERAL MOTORS CORP.
  4. Install the reinforcement bar (2) to the chassis hitch bolt and end cap.
  5. Install the nuts (1, 3) and adjust the bumper height.

    Tighten:  Tighten the nuts to 32 N.m (24 lb ft).

  6. Install the push-in retainers in order to secure the bumper end caps.
    7. Fig 2: Electrical Connector For Trailer Tow Receptacle
    GM1453814Courtesy of GENERAL MOTORS CORP.
  7. Install the trailer tow receptacle (2) to the rear bumper (1).
  8. Install the bolts (3).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals