LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Bumpers And Fascias) >> Repair Instructions >> Rear Bumper Replacement (SUT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Spare Tire Carrier Mounts
    GM1453818Courtesy of GENERAL MOTORS CORP.
  1. Position the rear bumper (1) to the chassis frame.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 2 rear bumper bolts.

    Tighten:  Tighten the bolts to 32 N.m (24 lb ft) at the spare tire carrier mounts.

  3. Install the rear tire carrier mounts (2, 3) to the bumper.
  4. Install the bolts (1).

    Tighten:  Tighten the bolts to 100 N.m (74 lb ft).

    5. Fig 2: Reinforcement Bar & Related Components
    GM1453817Courtesy of GENERAL MOTORS CORP.
  5. Install the reinforcement bar (2) to the chassis hitch bolt and end cap.
  6. Install the nuts (1, 3) and adjust the bumper height.

    Tighten:  Tighten the nuts to 85 N.m (63 lb ft).

    7. Fig 3: Push-In Retainers
    GM1467112Courtesy of GENERAL MOTORS CORP.
  7. Install the 2 outer bumper end caps (2) and secure the push-pin retainers.
  8. Connect the rear park lamp electrical sockets.
    9. Fig 4: Electrical Harness Loom
    GM1467118Courtesy of GENERAL MOTORS CORP.
  9. Secure the electrical harness loom (1) to the rear bumper bracket (3) with a new tie strap (2).
  10. Install the push-in retainers in order to secure the bumper end caps.
    11. Fig 5: Electrical Connector For Trailer Tow Receptacle
    GM1453814Courtesy of GENERAL MOTORS CORP.
  11. Install the trailer tow receptacle (2) to the rear bumper (1).
  12. Install the bolts (3).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    13. Fig 6: Rear License Plate Harness Electrical Connector
    GM1467091Courtesy of GENERAL MOTORS CORP.
  13. Secure the rear bumper step cover (1). Refer to Rear Bumper Step Pad Replacement .
  14. Secure the license plate harness grommet (2) to the bumper cover.
  15. Connect the trailer tow receptacle electrical connector.
  16. Install the top rear bumper step pad. Refer to Rear Bumper Step Pad Replacement .
  17. Install the spare tire carrier. Refer to Spare Tire Carrier Replacement .
  18. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
  19. Install the 2 rear lower wheelhouse liner bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals