LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Bumpers And Fascias) >> Repair Instructions >> Rear Bumper Filler Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Spare Tire Carrier Frame & License Plate Pocket
    GM1453826Courtesy of GENERAL MOTORS CORP.
  1. Remove the license plate pocket.
  2. Remove the spare tire from the carrier assembly (2).
    3. Fig 2: Harness Grommet
    GM1486513Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the rear license plate harness connector behind the rear bumper.
  4. Release the harness grommet from the rear bumper cover.
  5. Open and remove the spare tire carrier from the spare tire carrier mounts.
    6. Fig 3: Spare Tire Carrier Mounts
    GM1453818Courtesy of GENERAL MOTORS CORP.
  6. Remove the spare tire carrier mounts (2, 3) from the rear bumper bar (4).
  7. Remove the rear bumper. Refer to Rear Bumper Replacement (SUT)  or Rear Bumper Replacement (SUV) .
    8. Fig 4: Wheelhouse & Related Components
    GM1453833Courtesy of GENERAL MOTORS CORP.
  8. Remove the inner wheelhouse panel lower 2 rear bolts in order to access the bumper end cap bolts.
    9. Fig 5: View Of Right Side Filler Panel
    GM1453820Courtesy of GENERAL MOTORS CORP.
  9. Remove the right side filler panel push-in retainers (2) first.
  10. Remove the right side filler panel screws.
  11. Remove the right side filler panel nuts (4) from the outer edge.
  12. Remove the right filler panel from the vehicle.
  13. Remove the left side filler panel push-in retainers (6).
  14. Remove the left side filler panel screws.
  15. Remove the left outer filler panel nuts (7).
  16. Remove the left side filler panel (5) from the outer body panel (1).
scientia non olet · About LEMON Manuals