Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Install the front bumper assembly to the vehicle.

Fig 1: Front Bumper Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the 2 upper bolts to the bumper bar.
Tighten: Tighten the bolts to 85 N.m (63 lb ft).
Connect the electrical connector to the DRL.

Fig 2: View Of Fascia Plugs

Courtesy of GENERAL MOTORS CORP.

Install the 2 plugs (1) to the front fascia (2).

Fig 3: Bumper Bar Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 2 lower bolts to the bumper bar.
Tighten: Tighten the bolts to 85 N.m (63 lb ft).

Fig 4: Grille & Brush Guard

Courtesy of GENERAL MOTORS CORP.

Install the front grille guard, if equipped. Refer to Grille Guard/Brush Guard Replacement (Base) or Grille Guard/Brush Guard Replacement (WS2, V3M) .